180° Dual-Technology Occupancy/Vacancy Motion Sensor Wall Switch

180° dual-technology occupancy/vacancy motion sensor wall switch, neutral wire required, single pole, white finish, 120/277VAC,50/60Hz voltage.

DESCRIPTION

This Multi-Technology Wall Switch Sensor combine advanced passive infrared (PIR) and ultrasonic technologies into one unit. The combined technologies helps eliminate false triggering even in diffi cult applications. Selectable operating modes allow the sensor to turn a load on, and hold it on as long as either or both technologies detect occupancy . After no movement is detected for the selected time delay, the lights switch off. A “walk-through” mode can turn lights off after only 3 minutes, if no activity is detected after 30 seconds following an occupancy detection.

This sensor also contains a light level sensor. If adequate daylight is present, the sensor holds the load OFF until light levels drop, even if the area is occupied.

FEATURES

• Integrated PIR and Ultrasonic sensor technology to detect very fi ne motion and provide accurate motion sensing
• Allows to choose triggering when both technologies detect motion or when only PIR detects motion
• Less false trigger, fast ON/OFF; commercial grade sensor for closet, garage, hotels, meeting room, work places
• Adjustable timeout from 15 seconds to 30 minutes; WalkThrough mode: 3 minutes if no activity after fi rst 30 seconds

SPECIFICATIONS

• Voltage: 120/277VAC,50/60Hz
  Load Requirments:
• Incandescent: 800W-120VAC,50/60Hz
• Fluorescent: 800VA-120VAC
                     1600VA-277VAC
• Resistive: 800W-120VAC,50/60Hz
• Motor: 1/4HP-120VAC,50/60Hz
• Adjustment Time Delay: 5 Sec to 30 Mins
• Walk-Through Mode: 3 minutes if no activity after 30 sec.
• Test Mode: 5 sec. at initial power up or DIP switch reset
• PIR Adjust: High or Low (DIP switch)
• Ultrasonic Adjust: Minimum to Maximum (trimpot)
• Light Level Adjust: 100 Lux - daylight(trimpot)
• Operating Temperature: 32° F - 131° F